How can the air compressor be repaired and maintained?
Condensate discharge:The moisture in the air may condense in the tank, especially in wet weather, when the exhaust temperature is lower than the air pressure, dew point or stop cooling, more condensed water will be precipitated. The oil contains too much water will cause the oil emulsion, affect the safe operation of the machine, such as: bad compressor lubrication; oil and gas separation effect becomes worse, oil and gas separator pressure difference caused by corrosion of parts. Therefore, the condensate discharge schedule shall be established according to the humidity conditions.Condensate discharge method: should be in the machine shutdown, oil and gas separation tank without pressure, sufficient cooling, condensate after sufficient precipitation, such as before the start of the morning.Screw out the front plug of the ball valve at the bottom of the tank.Slowly open the ball valve drain until the oil flow out, close the ball valve.Screw the ball valve before the screw plug.
Clean cooler:Air compressor every run 2000h or so, in order to remove the heat radiation surface dust, need to fan support on the cooler sweep Kong Gai open, with blowing dust air gun on the cooler blowing, until the heat radiation surface dust sweep clean. If the dirt is difficult to heat surface seriously, purge and clean the cooler can be unloaded, pour in the cooler oil and the four import and export closed to prevent dirt from entering, and then use compressed air to blow the dust or water washing on both sides, the last blow the surface water. Return to original position. Remember! Do not use iron brush hard scraping dirt, so as not to damage the surface of the radiator.
