Home > categories > Minerals & Metallurgy > Ductile Iron Pipe Fittings > How can the ductile iron pipe be punched?
Question:

How can the ductile iron pipe be punched?

How can the ductile iron pipe be punched?

Answer:

Ductile iron should be drilled, the key is to see how big holes. If it is a small hole, you can consider using a small drill around 5mm to slowly wear the pipe, and then gradually reaming. If the fight is relatively large hole, may according to the aperture required first hit a circle hole, and then use a small chisel chisel down, slowly put the plate again to be trimmed. When drilling, add a little oil to cool the drill bit.
Main points: manual hydraulic drilling machine and drilling machine, drilling machine is to rely on human features manually through the drill holes in the pipeline: the need for manpower and time, simple operation and economic benefits; characteristics of the hydraulic drilling machine is through the electric pump or gasoline pump driven drill holes: human, mechanical opening. The need for daily maintenance, high cost. General aperture 300mm can be done by hand drilling machine
Ball milled cast iron pipes can be opened and the opening size depends on the main pipe. For example, the main pipeline is DN100, diameter 118 milling pipe, can open the 100mm maximum aperture (with aperture opening), commonly used manual opening now the minimum 20mm, maximum 600mm, maximum 800mm hydraulic hole, open hole drilling machine dedicated

Share to: