How can the paver be leveled?
Depends on the level of the instrument, and for different roads, there are different settings, can not be generalized. And your question is too general. By the way, what you are talking about is the calibration of the initial angle of the paver. Paver in the factory is to debug platform calibration, paver test bench is very accurate, and the use of the calibration process is to determine the precision of height gauge and a feeler gauge. What is your company's calibration in mm?... Long knowledge, ha ha.
Adjusting the initial elevation angle of the ironing device, the two leveling oil cylinder fully extends back to retract 50mm, and the back edge of the screed plate is used as the datum, and the front edge raises 4mm, and the pointer of the leveling cylinder and the rear end pointer of the big arm are all refer to the 0 position.
Look at the instructions, and if the instructions are gone, go to someone else's official online, next manual. Ha ha, our units produced paver when ironing plate is so adjusted, you can refer to.
