How can ultrasonic plastic welding machine replace ultrasonic mould?

Answer:

How can ultrasonic plastic welding machine replace ultrasonic mould? First, the ultrasonic transducer horn contact the mold place, with cloth or alcohol wipe clean, followed by ultrasonic, mold a little to tighten!

First, the ultrasonic transducer horn contact the mold place, with cloth or alcohol wipe clean, followed by ultrasonic, mold a little to tighten!

Adjustment method for ultrasonic welding mold replacement(1) start the work of ultrasonic equipment, air pressure source to ensure the normal index of equipment barometer(2) use the special wrench to remove the original welding die on the equipment and install the ultrasonic mold which needs to be welded (clockwise is loose, be sure to tighten), and pay attention to tighten the screw of the mould first.(3) connected to the power ultrasonic equipment, open the start button to wait for five seconds, turn off the power, then press the sonic detection button on the controller, the machine makes ultrasound (hear the sound is ringing, no noise, hoarse and excess) if hoarseness or scream, must check whether the mold has broken or loose, and take countermeasures.(4) loosen the two fastening handles at the back of the starting frame and roll the machine head up to a certain height. (according to the height of the product)(5) close the gas source. Adjust the barometric pressure to zero(6) place the welding products on the bottom die and ensure the die closing.(7) pull down the whole mold vibration cylinder, make the upper die close to the bottom mold, shake the head lifting device, make the upper mould press to the product, and keep the product and the upper and lower mold match.(8) add air pressure to 0.1MPa, select switch to manual, press two green start button, make die down, and press product.(9) shake the lifter to keep the spacing screw and the vibrating cylinder 1MM distance (according to the product that needs to be welded)(10) tighten the fastening handle of the frame, fix the bottom die, press the red emergency stop button, and make the nose rise.(11) select the switch fluctuation automatically, adjust the welding parameter and time of the product, and prepare the production