Ultrasonic plastic welding machine die wave is not strong, how to repair?
Isn't there enough frequency?
Under normal conditions, ultrasonic welding machine can repair the ultrasonic welding pattern.
The gray section of the section (whether it looks like a powder after breaking) should be caused by excessive welding and possible causes:1, the welding time is too long, can be appropriate to reduce the delay time or welding time, welding speed or decrease;2, the machine power is too large, you can reduce gear, or choose a smaller power of the machine.If it feels that the wave is not strong, it can be modified as follows: reduce the total height, increase the frequency, and increase the waist height to reduce the frequency. But be careful not to drift out of the best total height.In addition, there may be a strong wave transfer mode is improper, as current mode without impaction, not adjusted to the best state.
