How do I fit the carpet in the billiard hall?
Fixed laying: there are two kinds of fixation methods of laying a fixed type, a card is a fixed type, pull the carpet with barbed plate; a bonding method is fixed, the use of adhesive paste in the carpet on the floor.
Carpet laying: carpet has carpet and roll carpet in two forms, using different laying methods and laying position.Movable laying: refers to the carpet pendulum, floating on the base, without carpet and grass-roots fixed.
(1) a card type fixed way: the primary cleaning treatment, carpet cutting, nail spinicarpous plate, cushion layer, seam, Zhang Ping, fixed to the edge to repair the carpet cleaning, carpet surface.(2) paste method fixed: grass ground treatment, volume, line cutting, scraping, hanging carpet laying silver pressing, cleaning, protection.
Note: pay attention to finished product protection, glue paste carpet, not allowed to tread within 24 hours. Carpet pavement on the ground floor of the higher requirements, the ground must be smooth and clean, moisture content shall not be greater than 8%, and has been installed kicking baseboard, skirting board to the ground floor gap should be larger than the carpet thickness of 2~3 mm. Accurately measure room size and calculate material size so as not to waste. After the carpet is laid, be sure to tighten, Zhang Ping, fixed, to prevent future deformation.
Construction points: before paving, must carry out the actual quantity, measure whether the corner of the square, accurately record the angle of each angle. According to the calculation of the size of the material in the back of the carpet, the line, cutting. The pull of fixed laying along the wall nail spinicarpous plate, pull from skirting board 8 mm. The joint application of adhesive tape in the carpet will be two pieces of carpet glued together, first seams not neat villi Xiu Qi, and repeatedly rub joints Department hair to the surface to see concrete evidence to. Bond laying after hanging frictioning 5~10 minutes, until the glue to be laying sticky when dry. Carpet laying, with the support of the needle carpet taut, Zhang Ping, hanging on the barbed plate. After the carpet is made of glue, the bubbles are extruded by felt rollers. The extra cleaning off the carpet to the linesman, fiber. When cutting carpets, they should be cut along the warp of the carpet. Only the weft is cut and the warp is not cut. For the carpet with backing, the hairs should be separated from the front, and the warp and weft shall be cut.
