How do I get rid of all the control circuits and connect the three terminals of the refrigerator compressor directly?Yes, I have a broken refrigerator. Today I took the compressor as a whole and wanted to connect it directly. But I saw three white terminals. How should I connect it? Don't put it on the refrigerator. I just want a light compressor to run independently. I try to connect, the compressor is just buzzing, does not turn, and what is the reason? How should I take it to make it work properly? Answer!If there is a satisfactory answer, add a reward! StopCan the compressor specific oil be added to the car oil? Will not produce god horse chemical reaction?
Hello Three terminal you said, the above should have three letters (M, C, S mark) where C is the common end connected to the zero line, M and C are running S and C start winding, winding; to start winding to rotate the compressor power to power winding! You are missing a startup component (starting the relay);However, you can try to manually start, but be sure to pay attention to security, the method is as follows:The M terminal is connected to the power line, the C terminal connected to the zero line of the power supply, in the terminal S leads to a line standby power on M and C; in the moment the terminal S leads to a line and FireWire lap, until the compressor starts rapidly after take off to! Please try, and please do good safety, pay attention to life safety!
You also need to start the capacitor. The compressor is taken as a whole, and if it runs, the refrigerant and the lubricant do not burn the compressor's internal motor.
Hello Three terminal you said, the above should have three letters (M, C, S mark) where C is the common end connected to the zero line, M and C are running S and C start winding, winding; to start winding to rotate the compressor power to power winding! You are missing a startup component (starting the relay);However, you can try to manually start, but be sure to pay attention to security, the method is as follows:The M terminal is connected to the power line, the C terminal connected to the zero line of the power supply, in the terminal S leads to a line standby power on M and C; in the moment the terminal S leads to a line and FireWire lap, until the compressor starts rapidly after take off to! Please try, and please do good safety, pay attention to life safety! ?Can increase the oil, if only when the pump, add enough, can move back to the trachea tilt angle of 30 degrees and no oil dripping on the line, a little more or less, the operation of the compressor will be thrown out! You can start from one point to the right point, because it doesn't take long to run, so there's no need to add too much!
