How do I get the carpet joint?
No fixed laying method: carpet cutting into a whole piece of adhesive joint, direct spreading on the ground, with the ground around the corner to trim the bond. This approach is suitable for the ground often rolled up the carpet or not often, weight room. Fixed: the carpet will be cut and bonded, into a seam, and around the floor of the room to be fixed. By using two kinds of methods: one is the carpet around the surface and the ground paste with binder or double-sided tape; the other is a wooden card with our upward nail in the room installed in the surrounding ground, the carpet back in a nail on a small wooden card.
Two kinds of methods of carpet seam (1) with sew two pieces of carpet bottom connected. (2) the glue on the adhesive tape should be heated to melt and paste. Iron can be hot melt, will be on it. When pasted, the adhesive tape is placed at the joint of the carpet. An iron is used to melt the adhesive on the paper surface, and the other is to press the carpet on the adhesive tape that has just been melted.
Sequence of operations (1) dimension of carpet. Each piece of carpet length less than the length of the room is about 5CM, the width of the cut to the edge of the carpet thread size calculation and test shop carpet positioning, cutting blanket material, to make the interface carpet wool direction, to avoid the surface of yin and yang. (2) to cut the carpet on the floor, the first fixed one side, then tensioned by a tensioning device and the carpet seam splicing method. The carpet in the laying process, we should pay attention to the carpet wool fabric consistent direction and light direction, in order to reduce the adverse effect when walking left inverse hair marks resulting in light of the mess imprinted on the carpet. (3) the wall knife trimmed the carpet, the carpet will be available flat shovel overturned in a wooden card into the nail to be fixed, with the final sealing strip, and vacuuming the carpet dust.
