How do the large and medium-sized loaders start?
I. check the vehicle1. check fuel, cooling water and lubricating oil.2. check the reliability of running and parking brake.3. check the no-load operation of the bucket system.4. check forklift contents in forklift contents.Two. Start1., before starting to observe four weeks, confirmed that no obstacle to traffic safety protection, first whistle, after starting.2. brake barometer readings must reach the required value before starting.3., start not suddenly accelerated, should start smoothly.Three. Drive1. remove the front and rear body safety connecting rod before driving and keep it properly.2. when driving on the ramp, the drag start lever should be placed on the switch position, and the tow start must be positive.3. change the direction of travel and change the drive lever must be carried out after the car stops.4. when carrying materials, should keep the lower hinge of the moving arm from the ground more than 400mm, shall not lift the bucket to the highest position to transport materials.Four. Loading and unloading operation1. when the temperature of the engine and the temperature of the lubricating oil reach the specified value, the full load operation can be carried out.
Air break? Hand brake? Handbrake. Look at the oil and water do not open standards, electric lock, and then tighten the flint, look up the shifting hydraulic gear, no gas (loader is automatic separator) big arm, the pedal to the left over
