Home > categories > Telecommunications > Repeater > How do the relays connect two routers?
Question:

How do the relays connect two routers?

How do the relays connect two routers?

Answer:

That's all right.The router itself is no problem, you know the network structure is not deep enough.The repeater front only provides a network data signal, so you can only have one signal when you connect the two routes at the same time. Go online and check the router function and the location of the network structure, and you'll see.And what you finally said is the connection method. That really guarantees that all ports on the two routers can go up.
[setting up sub router]1, access to the secondary router settings interface.2, click [network parameters] --- [LAN port settings].3, set the LAN address of the secondary router to 192.168.1.2 to prevent conflicts with the main router, and also facilitate the management of the master and secondary routers.4, click [wireless settings] --- [basic settings].5, set SSID to TP_LINK-B. Set up wireless channel for: 11.6, check the [WDS] open, in the pop-up interface click on the scan, get a list of AP later found the main router SSID, namely TP_LINK_A, click the right button [] link encryption, WPA-PSK, key fill main routing key: 12345678 (with a master router can), click save.7, click [wireless settings] --- [wireless security settings], set up sub routing wireless password here.8, click [DHCP server] --- [DHCP server settings], [address pool starting address] to 192.168.1.150, [address pool starting address] changed to "192.168.1.199". [gateway] fill in the IP address of the main router, that is, 192.168.1.1. The master and alternate DNS servers write down the addresses that were recorded before, save and restart the routers.9, set up, the connection is successful.
1, enter the main router interface settings, and then click options in the left section [running state], in the WAN status bar can be found on the DNS server, a total of two, the main DNS and the standby DNS server record.2, click [network parameters] --- [LAN port settings], the router's LAN address is set to 192.168.1.1 save, at this time will restart, restart, back to the settings interface, click [wireless settings] --- [basic settings].3, set SSID to TP_LINK_A. Set up wireless channel for: 11. Note: you must turn off the WDS or Bridge function.4, click [wireless settings] --- [wireless security settings], encryption selected WPA-PSK, in this case 12345678 as an example. Note: WPA/WPA2 encryption is more secure and bridges more stable than older WE encryption, so WPA/WPA2 encryption is recommended.5, click on the [DHCP] - [server DHC server settings], [the address pool starting address is set to the [192.168.1.100]; address pool end address] is set to 192.168.1.149 Click Save and restart the main router. The main router settings are complete.

Share to: