what tools should you use
Tools: X-acto knife or any thin sharp thing to get uder the rubber lid, Bottle with a 1 inch or bigger hole Paint thinner, towel, BONES BEARING OIL DO NOT USE WD-40!, and skate tool. First take off your wheels, then pop off your bearing, put the end of the X-acto knife under then up off the rubber shield, Fill your bottle with 1 cup of Paint thinner, SHAKE for about a minute, dispose solvent safely while holding cap un-screwed on the hole just letting the liquid out, put bearings on towel, wipe them to get any excessive paint thinner off, 2-3 drops off lube, put rubber shields back on then give the bearings a spin, Put them back in order on your trucks. REMEMBER do no use any Water and clean any dirt, dust, etc off your bearing before putting them in your bottle! Hope this helps!
a soft bristle brush and solvent.....
