How do you solve the problem of stepping motor jitter
It is usually possible to set the current value on a finalizer, and try it on a smaller scale. Note that too small a current can cause jitter, but the noise is low, not obvious. Also, the current is too small, high-speed rotation may need longer acceleration time, highest speed will be limited, need to find a balance between the two.
What you said, step by step, vibration is like shaking a step motor, or other, under normal circumstances, the motor power is, suddenly will shake once, this is normal phenomenon. Because electrical motors will look for an initial phase point in a second. There will be no jitter in the run, and there are several possibilities when there is a situation: The breakdown of the drive is not good, and if it is subdivided, you can either reduce the breakdown or increase the pulse frequency. The driver current is not sufficient to see if the driver current is in the working current area The motor is too heavy. Provide enough voltage. You can solve your problem if you have no problem with the equipment Satisfaction please adopt
Parallel motors can reduce jitter, possibly because the current is too large, low speed is small, the current is very large, it can cause vibration and noise. In parallel, if the total current is still so large, the current will be small for each motor, so the vibration and noise will be small.
