Home > categories > Home Appliances > Ice Makers > How does an ice maker work?
Question:

How does an ice maker work?

How does an ice maker work?

Answer:

The power indicator light has been flashing fast ice making machine machine always detect the water temperature probe circuit does not work; open back, open the electrical control box cover above the compressor, find a three core connector, check off or bad contact phenomena can be re inserted.If the ice machine ice three lights flashing, the machine does not work; because the ice making machine and ice shedding is not normally require a reboot,
In use, sometimes ice machine, the machine into the ice removal program (water pump stops working, compressor stop cooling), but ice does not fall off; that is two way solenoid valve damage. Replace the solenoid valve or external loop.When the ice machine water shortage light, but the machine does not automatically enter the water supply; check whether the pipeline is no water or water, solenoid valve failure, the valve does not open. Maintenance methods if no water, then open the water after the restart, if the water solenoid valve is faulty, then replace.
There are so many reasons, too many questions, nothing to say, and no definite answerIce free, not ice, such as compressor work, but not refrigeration, which may be the reason for the leakage of refrigerant or two way solenoid valve damage, closed lax. You can find the reasons for maintenance, the method is: after adding cooling liquid leak repair or replace solenoid valveIn use, there will be refrigeration ice, but not out of ice, this is because: measuring water temperature probe failure, so that intelligent control system can not effectively perceive the water temperature and work, miscarriage of justice, procedures, errors, or controller failure. The multimeter is used to measure the temperature of the resistance probe (the water temperature in the water tank near 0 degrees C, remove the control box of the three core lines, two lines on both sides of the resistance test), such as resistance in more than 27K, it was judged as controller bad, should be replaced, such as resistance of less than 27K, it shall be disconnect any two lines in a way, through the series resistance of the resistance to 27K to 28K.

Share to:

Hot Tag