How small satellite TV receiver installation and debugging
You can download a finder wizard, receiving local angle calculation. Don't block the pot. Connect the line, press the information key, the signal strength and signal quality bar (after the line is connected, the signal strength is about 50~~70), first adjust the elevation angle
Signal strength is red, can only indicate that the connection line is normal, it is best to tune to green, just pointing at the stars. You can refer to these places to rule out the problem:01, the stability of the pot is good?02, elevation and azimuth is correct, you can adjust side view, it is best to put the pot and TV closer to facilitate debugging, check the signal strength, mainly to tune the quality of the signal,03 see if there is interference.
The signal strength to the highest, then adjust the azimuth angle, nine in our country are generally about thirty degrees from the South West, South West slowly turn pot, the signal quality and to the highest, finally can turn a little tuner, the signal to the highest, see all are closed down, fixed on it
