How to assemble and disassemble the electric motor?,
Some open at the end without the line! Turn on the motor three to four times. Don't knock on the head, the end of the motor is easy to knock! General motor water rust will be difficult to open, and slowly knock, and must pay attention to the spindle shaft of the wire, do not screw pattern deformation. A screw that can be used on a motor shaft to prevent deformation or deformation! }
If you remove the line with the end of the screw motor, has a brush must be demolished with the end of the line, because without the other end with you is to knock out the commutator motor, both ends of the brushless can be removed, but to prevent knock to the motor line, so generally open with line end of motor with gear is special, we must pay attention to, some open at the wire end
Electric vehicle battery exchange agency for your answer: first remove the motor, unscrew the screws with the flywheel side (side, popular point is that there is no motor without the other side of the line, unscrew the screw with the flywheel side) to ensure that the motor is fully unloaded, and then hold the ends of motor in symmetrical, looking for a relatively thick point (wood to ensure that the thread of central axis is not destroyed), no motor line side down knock on wood, force must be steady, accurate and relentless. Bang bang, the cover is opened. Then you can take out the rotor. When installed, in turn, you can use the screws symmetrically fastened on it. Welcome to join the battery exchange of electric vehicles. If you are satisfied with the answer, please give the group a bonus. Thank you!
