How to carpet! To specific operation!
Carpet laying in wood or cement ground, pits, pits on the ground with sandpaper to draw with putty filled, then rinse the ground dry stand-by with water.
Not fixed: the carpet will be cut into a whole piece of adhesive joint, direct spread on the ground, with the ground around the corner to trim the bond. This approach is suitable for the ground often rolled up the carpet or not often, weight room.Fixed: the carpet will be cut and bonded, into a seam, and around the floor of the room to be fixed. By using two kinds of methods: one is the carpet around the surface and the ground paste with binder or double-sided tape; the other is a wooden card with our upward nail in the room installed in the surrounding ground, the carpet back in a nail on a small wooden card.
(1) the ground should be cleaned first, without stones, wood chips and other debris.(2) the carpet glue, laying must be neat, I use adhesive tape glued interface. Such as using double-sided adhesive tape, it is simple, economical, practical and effective. Both sides of the adhesive tape are covered with glue, and the plastic film is used to cover the adhesive layer. When the utility model is used, the film is peeled off and pasted on the glued object.(3) pay attention to the carpet and the wall, line, angle and so on, should be attached tightly, and must not leave the seam and edge up and so on.(4) carpet interface to listen to the design should be coherent, consistent color, joints should be hidden and not exposed.
(1) the size of the carpet. Each piece of carpet length less than the length of the room is about 5CM, the width of the cut to the edge of the carpet thread size calculation and test shop carpet positioning, cutting blanket material, to make the interface carpet wool direction, to avoid the surface of yin and yang.(2) to cut the carpet on the floor, the first fixed one side, then tensioned by a tensioning device and the carpet seam splicing method.The carpet in the laying process, we should pay attention to the carpet wool fabric consistent direction and light direction, in order to reduce the adverse effect when walking left inverse hair marks resulting in light of the mess imprinted on the carpet.(3) the wall knife trimmed the carpet, the carpet will be available flat shovel overturned in a wooden card into the nail to be fixed, with the final sealing strip, and vacuuming the carpet dust.
Two methods of patchwork blanket(1) sew the bottom of the two carpets together.(2) bonding with glue.The glue on the tape should be heated to melt and paste. Iron can be hot melt, will be on it. When pasted, the adhesive tape is placed at the joint of the carpet. An iron is used to melt the adhesive on the paper surface, and the other is to press the carpet on the adhesive tape that has just been melted.
