I know where to change the screw, and also know how to turn the three patch, but I don't know how to make the code. Which iron piece is the first one? Second below, corresponding to the middle? But turn second and third times, all the patches are in rotation, it will not toss, ask which master detailed and detailed, once again, thank you, to give extra points.
The first password found, take it as the starting point to the left slip ring, and find the first password "looked inside the blade" and then turn left the dial, until the "leaves" the true gap alignment with the guide column, look at the code plate alignment red dot is second digital password. The next and then hand directly turn the dial, see the inside of the outer blade "is really" gap alignment with the guide column, the code plate number is third at the red dot group password. Three sets of new password found, do not rush to shut, open the door in the state after repeated trial several times, to confirm the new password open, then shut the door.
The second step, looking for a new password, first hand out two weeks after the password right idle disk, looked again at the door inside the lock inside the "blade", now continue to turn dial outside by hand, until the real gap guide column on the blade alignment and the outside of the safe lock linkage (open wrench when the guide column is inserted into the gap), now look at the code plate of the first group of the new password to the red dot number is safe
First of all, we should know how to open the mechanical code lock. The first step, first remove the inside of the door of the safety door, the screw on the dial for any hole, and now the secret code changed.
