How to clean ordinary hydraulic bending machine?
low roughness of the hydraulic valve body, the use of nylon balls with abrasive ball to brush, brush the end of the valve hole, the junction of the tunnel and sinking groove and so on. The nylon brush to brush the brush from the diameter of 0.3-0.6mm black nylon wire and specifications for the m20 green silicon carbide abrasive bonding
motor scrub can use soft brush to remove dirt, in order to maintain the accuracy of components and low roughness. Such as net-type oil filter, always with a hard wire brush, and sometimes damage the filter or change the filter accuracy. Another example is the high precision
spray the use of pressure jet cleaning, suitable for large and medium-sized factory workshop continuous operation. Through the corrosion-resistant pump bar deployment of a good hot water solution to 0.3mpa pressure jet cleaning, in general, was cleaned parts through the pre-wash room, cleaning room and hot water cleaning chamber three continuous jet process. In addition, the air generated by compressed air can als
solvent impregnation cleaning impregnation cleaning is to be cleaned the hydraulic machine parts immersed in a heating device with a cleaning tank (heating temperature is generally 35-85 degrees Celsius), and in the cleaning fluid into the compressed air or steam, so that the cleaning solution in the Dynamic, the immersion time 4-8 hours, for serious oil parts, cleaning need to hand wipe.
