Home > categories > Lights & Lighting > Ballasts > How to connect the tube of fluorescent lamp to the six wires of the electronic ballast line
Question:

How to connect the tube of fluorescent lamp to the six wires of the electronic ballast line

How to connect the tube of fluorescent lamp to the six wires of the electronic ballast line

Answer:

Electronic ballast output for fluorescent lamp tube: The electronic ballast should be four lines, and two of the six lines are powered. The outer two lines of the output end (four lines) are connected to the lamp tube, two of which are not used. Desk lamp bulb looks two needle, is actually four needles, two needles in the concatenated capacitance inside the tubes, and a capacitor inside the tubes, so you don't have to pick up these two root, the root is for not capacitance of the tubes.
The filament of the lamp tube passes through the ballast. When open the starter and ballast can produce high feeling on the ends of the tube filament, filament electron bombardment wall of fluorescent powder, repeated several times to break the starter, such movement will be repeated several times, to get through tubes.
On the ballast is fluorescent lamp current limiting effect and the production of instantaneous high pressure equipment, it is made in silicon steel core put enameled wire, such iron core coil, open/close the electricity in an instant, can produce high voltage, self inductance on the electrodes at the ends of the tube (filament). This action is alternating, when the regenerator (bubble) closes

Share to: