Home > categories > Machinery & Equipment > Lead Rails > How to determine the mounting position of the guide bracket?
Question:

How to determine the mounting position of the guide bracket?

How to determine the mounting position of the guide bracket?

Answer:

1, in determining the position of the guide bracket at the same time, but also consider the rail connection plate (link plate) and rail bracket) 1 can collide. Staggered net distance is not less than 30mm. 2, longer than 4m (including 4m) car rails, each should have at least two rail brackets. 4m to 3m long car rail is not subject to this limit, but the guide rail spacing shall not be 2m. If the manufacturer's drawings are required, they shall be constructed according to their requirements. 3, if the drawings are not clearly defined, the lower level rail support is taken as the base point, and every 2000mm is a row of rail brackets. Elsewhere (in case of said plate) spacing can be properly enlarged, but should not be ten 2500mm. 4, there is no elevator rails, brackets, buried iron elevator shaft lining, according to the requirements of the drawing guide bracket spacing, size and installation of the rail support vertical song to determine the guide rail bracket in the wall of the location. 5, when the drawing does not specify the next row guide rail bracket and the top row of the rail bracket position should be determined according to the following provisions: the next row guide bracket is arranged at the position corresponding to the pit decoration above the ground 10001m. The smallest row of racks is installed below the roof of the hoistway, no more than 500 m M.
Determine the mounting position of the guide bracket:1, no rail support, pre buried iron elevator shaft lining, according to the requirements of the drawing guide bracket spacing, size and installation of the rail support vertical to determine the location of the guide rail in the wall.2, when the drawing does not specify the next row guide rail bracket and the top row of the rail bracket position should be determined according to the following provisions: the next row guide bracket is arranged at the position corresponding to the pit decoration above the ground 1000mm. The top row of racks shall be installed below the roof of the hoistway, no more than 500 m M.3, in determining the position of the guide bracket at the same time, but also consider the rail connection plate (link plate) and a guide rail bracket cannot collide. Staggered net distance is not less than 30m M.4, if the drawings are not clearly defined, the lower level rail support shall be taken as the basic point, and every row of the rail bracket at the top of every 2000mm. Elsewhere (in case of said plate) spacing can be properly enlarged, but should not be greater than 2500mm.5, longer than 4m (including 4m) car rails, each should have at least two rail brackets. 4m to 3m long car rail is not subject to this limit, but the spacing between the guide brackets shall not be greater than 2m. If the manufacturer's drawings are required, they shall be constructed according to their requirements.
In determining the position of the guide bracket at the same time, but also consider the rail connection plate (link plate) and rail bracket).Guide (TTW): metal or other materials made of grooves or ridges, can withstand, fixed, and guide the movement of devices or equipment, and reduce its friction of a device. A longitudinal groove or ridge on the surface of a guide, used for guiding and fixing machine parts, special equipment, instruments, etc.. The guide rail, also known as linear guide, linear slide rail, for linear reciprocating movement, linear bearings have higher than the rated load, and can bear a certain torque, can achieve high precision linear motion under high load. The main rail is divided into two major categories: roller guides and ball bearings.

Share to: