Home > categories > Construction & Real Estate > Wash Basin > How to disassemble the bumper of the wash basin?
Question:

How to disassemble the bumper of the wash basin?

How to disassemble the bumper of the wash basin? Home of the washbasin a little bit of water, want to remove all the hands to clean up, but found that the final step to this step when the bad, remove the following, followed by the above ... ... Will the master know how to demolition in the end it?

Answer:

1, the most simple way, on the hardware store bought one, this with a diagonal pliers or vise clamp blown destructive dismantling. 2, if you want to continue to use, it is only removed, in the bottom of the basin below the bottom of the basin water leakage, the upper part of the nut with a wrench to stay wrench, the lower with a rubber gloves hand tight, hands relatively force, Can be demolished.
May be a little rust live, with the board to twist the big nut, with pipe pliers to clamp the following thread, with pliers to clamp the wall may also line, do not turn can, once with full force
The sewer is a drainage device placed in a bathtub, basin, etc.. By type can be divided into bounce into the water, flip the water and pull the water and so on. According to the material can be divided into copper water, stainless steel water, plastic and other water. According to the use can be divided into bathtub water, basin and so on. The choice of the sink: This depends on whether the basin has overflow, if there should be selected with the opening of the water. If there is no choice should be no openings in the water.

Share to: