Home > categories > Electrical Equipment & Supplies > Inverters & Converters > How to disassemble the notebook power adapter
Question:

How to disassemble the notebook power adapter

How to disassemble the notebook power adapter

Answer:

4, between the shield and the circuit board is also separated by a layer of thick plastic film, and then cut off the knife after the United States, you can see the circuit board "Lushan true"
3, then open the shell of the power adapter, you can see the adapter circuit outside the package with a copper shield, with a knife to cut the shielding tape on the tape, and then use the soldering iron shield and the internal circuit board connected to the two Solder joints, you can remove the shield.
. 2, the power adapter on the side of the lateral side of the white paper, with an electric knife blade along the power adapter under the cover between the gap cut, and then hit the electric knife knife with a hammer, so that the electric knife from the adapter between the upper and lower cover cut into. In the different positions of the gap between the upper and lower covers of the adapter, use the tip of the electric knife to be scratched along the gap. When the upper and lower covers are first split, the depth of the tool is deep and then the upper and lower covers of the adapter are separated
HP laptop power adapter for the whole design of small sealed, you can follow the following steps to dismantle: 1, laptop power adapter for the injection molding package or with a strong adhesive glue, without any screws, so generally only with violence Cracked. However, as long as the method properly, after the dismantling of the power adapter can be restored to the original, do not carefully observe almost no traces of open.

Share to: