Just prepare basin filled with water, it must be large enough to allow you put both your hands, light bulb and bottle in it. You need bottle. Now with scizors poke and cut the twisted aluminium top somewhere in the middle. You will see that aluminium is soft for cutting, and peel it off. You will now have light bulb without aluminium and plastic on top. Next, put light bulb in water in inverted position, then get a screwdriver or scizors and break it from the top, which is now on bottom. Just punch it with scizors. You can also break some more sharp glass leftovers to make wider openning. Now, put filled with water bottle in water so it goes under water and invert it, just like light bulb. Now, reinvert light bulb, so all gas in it will, in the form of bubblesr go in inverted bottle on top (actual bottom). If it isn't coming out, try punching and shaking it. Or push the gas with scizors to enable it to go out. Eventually l.bulb will be filled with water and gas in bottle. In that position close the botle. Done.
