Home > categories > Rubber & Plastics > Rubber Rollers > how to get the bypassing blocking system?
Question:

how to get the bypassing blocking system?

how do u get past the blocking system so i can get on to my ******* myspace??????????

Answer:

As a matter of fact I did. It was a little yellow blanket that I always rubbed with my fingers. Back then when I had it, my grandmother bought me a identical yellow blanket and I just threw it out of my crib. I guess you could say I knew it wasn't the right one.
Go to the home improvement store and get.TSP, Primer and Paint. Also Rubber gloves, a bucket, a paint brush, a roller and a paint tray. You need to tip that air conditioner up a little to allow the water to drain outside. It should actually be further back then it is too, only the actual cover plate of the AC should be in the room The paper covering the opening on the right needs to be replaced with the stiff foam insulation. Lay plastic contact paper on the window sill. The moisture from the AC condenser needs to drip outside. Make sure the filter on the AC is clean. and look at the back to make sure that leaves or debis aren't in there look at the outside bottom of the unit to see if there is a small hole and make sure that it isn't clogged. The small hole is the drain. Check this hole often (weekly) to be sure it's not clogged. If the wall on the right of the AC is spongy you need to replace the piece of wall. Wash the discolored areas with the TSP (its a powder solution you mix with HOT water) and rinse well. If the wall is not spongy and the stain is still there spray some bleachAllow it to dry put a fan on it to dry it. Use the primer paint to cover anywhere it was discolored. Allow it to dry. If the dark portion bleeds through put another coat or 2 of primer there. Cut the foam to the exact hole opening. Fasten the foam insulation in the opening. You can do this with a hot glue gun. You can put the primer on the stiff foam too on the smooth side. Then paint.

Share to: