Home > categories > Construction & Real Estate > Tile > how to measure the bathroom for tiles?
Question:

how to measure the bathroom for tiles?

I want to buy lenulim tiles for bathroom. how can I measure how many do I need? and should I start putting in from the center? is there a link to watch? thanks.

Answer:

Measure Length and width then multiply the two measurements. This will give you the square footage for how many tiles you will need. When you go to buy- the carton will tell you how many square feet comes within the box. You should always start tiles at the center. This way if there are any tiles that need trimming, they will be at the edges of the wall and not in direct sight.
If your bathroom already had linoleum on the floor, just count the number there are. Start from the corner where your door is because you are going to have to cut some probably to go near your sink, and you do not want that showing on the opposite wall. I think they are usually 1 x 1 foot, and depending on how large your bathroom is (mine is small), it will probably only take one box of tiles. Get the kind that have paper on the back that you can pull off and just stick it down on the floor. That way, you do not have to mess with that glue stuff. It will stay stuck well if the floor is good and clean first.
If you are using large 1ft square tiles, and your friend did a bad job on the the mosaic tiles I wouldn't suggest doing it. The weight of the tiles may loosen the the smaller tiles causing the larger tiles to fall. This could be dangerous in a shower or bathtub area. The tiles may shatter leaving sharp little shards of tile everywhere, including in the flesh of anyone nearby. I was going to put 16 x 16 tiles in my shower area, and a contractor said I better be sure the wall above the shower is secure because if one came loose and hit me in the head it would not be good. I went with little 1 x 1 tiles on the ceiling with larger tiles on the wall. Whatever you put up is only going to be as secure as what's behind it. Just my opinion, but for safeties sake, I would remove the old tile and start over. Remember, there is never enough time or money to do it right the first time, but there is ALWAYS enough time and money to do it over!!!

Share to: