Home > categories > Security & Protection > Fire Alarm Control Panel > How to operate the control cabinet in fire control room?
Question:

How to operate the control cabinet in fire control room?

How to operate the control cabinet in fire control room?

Answer:

This is for professional training, and the one or two sentence is hard to sayGeneral cabinet is debugged, do not need to move.In daily work, the screen shows "the system is working properly.""As long as you can understand the line, simple operations to understand, such as reset, self-test, screen, muteThese keys are very clear, you can click on the operation, mainly you have to understand it, what are its use?. Note that some operations should be password, generally no password, you press the OK, you can enter the operation interface, if you have a password, you enter the password directly, press OK
This is the machine reset, return to a normal state, such as the machine alarm you after confirmation is not on fire, people mistakenly press the manual alarm button. You knob the button and reset it. The fire condition is still displayed on the control room host, and then you can press the reset button. Reset the engine from the fire alarm to a normal working condition.Self check ---- this is to check the machine itself, there is no problem, you can control the sound device, panels on all the lights, monitors for inspection.Shielding ---- this is not normal, there is a fault, there are facilities, temporary repair of the facilities, first shielding off, so that the system works properly, so that the fault first run back. After the repair, in the removal of shielding, such as a smoke sense is bad, and now there is no alternative can be changed, you can first put this "shielding" up, and so on, buy good, put on, in the "remove" shield".
Noise - - when a fire signal is issued, a fire alarm, and when an emergency occurs, an ambulance alarm sounds. Because the personnel on duty can not be twenty-four hours without blinking at the screen, so when I heard the alarm sound to see which position on the display alarm in the confirmation, then you can press the mute button, the sound stopped in check alarm ringing, always will be noisy. Silencing is for this purpose.Well, simply tell you this, and you'd better go to special training. The fire brigade should be organized. Because the fire control room requires certification. After the training has been issued, the fire control room can be put on duty.

Share to: