How to set the car rear seat
If it is not possible to hold special seating, a buckle place opened sleeve together, if it is a general seat by hard pull. Oh, but not bad.
Then according to the down button next to the rear backrest headrest backrest, remove the head (a hand to put on the pillow, one hand on the pillow sleeve out until the head rest with a flexible button). Set the backrest and the headrest sleeve.Two little back, if possible with a wrench or socket screw up down below is removed, no conditions with plastic sheet of the seat cover edge excess into the gap in the good side.So far, restore all, how to dismantle, how to install?!
If the front for me, open the driver side door, after the car left the car into the face, hands into contact with the vehicle in front of the rear seat cushion upwards until the crack in the forced open, then the same method and cushion the other end, such as this step and the back of the seat connections don't have to think of ways to remove the connection screw. Remove the rear seat, fasten seat connection sleeve sleeve belt, put aside.
Steps are as follows:1, the seat back slightly upward pull, the entire seat directly turned up;2. Place the seat on the seat and adjust the position;3 pull the rubber band at the front end of the back seat from the seat to the back and tie it to the back of the rubber band;4, the rear end of the rope tight tie tight;5, good finishing flat seat;The rear seat is installed!
