How to set up the house lightning protection?
The top of the hill is well done! In each of the two mountains, a steel bar is buried, and the lower end is buried underground! OVER!Flat top should be installed on the top of the lightning protection network, and then connected with the lightning rod, and then buried along the wall of steel or steel into the ground.Lightning protection network is: at the top of the building on the edge of the vertical direction, buy short bars, exposed wall about 10~20 cm, at intervals of about 50 centimeters, and then at the end of a long arc welding steel reinforcement, the short reinforced all connected. OVER! Don't forget to connect with the lightning rod placed in the middleThe grounding end is buried about 1 meters underground, and if conditions permit, some copper powder can be embedded at the bottom to help conduct electricity.
Rural houses1 floor beams, four corners welded steel reinforcement.2 beam four angle welding steel bars.3 steel strip welding beam shape, and on the slope before and after the steel tile pressed steel sling.4 hot water gas holder on steel flat belt.5, four corners with 16 steel bars, 2 meters nail ground welding.6 make another place for the fork.7 is doing a ground zero line.
It is possible to use the reinforcing bar of the constructional column as a lightning conductor, but because the reinforcing bar of the constructional column is wrapped in concrete, it is necessary to use the 10# steel bar to lead another ground. The 2.5 cm diameter rebar for grounding the best length of 1m, must be welded. There is no danger that the grounding channel is clear.
