How to solve the panel furniture open non explosive edge ```PVC edge, how can I do not see the combination?
Explosion. Side. Two reasons. One is bad is two sheet or blade is not good equipment.
I answered the question in detail! Look at my answer!Let me explain it to you!Sliding table saw is two blocks of the saw blade, a main blade, a small guide saw, sawing plates without paint finishes are generally only a piece of the main blade material, only saw a veneer plate was used to guide the small saw slot on a plank opposite to guide the use of the plate, so paint finish will not explode edge, also can also push table saw cutting board, with jargon and can open the wool can also open concentrate.Precision saw belong to larger equipment, which saw general factory to use, this is due to the large quantities of materials to use, and there are some guiding blades, and some are not, no guide blade will burst edgeAs for the plate with ordinary sawn out edge trimming machine and then to trim is not recommended that you use, trimming machine is only suitable for the scattered use, only for special components and good use effect, but also need to put parts of wool trimming trimming machine, if the batch production use, trimming machine will increase a lot of production and material costNow, the most practical thing for you is the platform saw
First of all, what kind of material do you use? What's on the board? If the hollow plate is recommended for automatic cutting saw, sawing straight, not easy to break down. Personally feel that the paste with melamine impregnated paper is most likely to collapse side, in case the particleboard material is not good, a little, simply do the dead! According to the sheet material you saw, choose the appropriate number of teeth, usually between peers is easily learned, again adjust the slot saw and main saw the same line, saw sawing width groove about 0.1MM than the main, if you saw the groove is a monolithic trapezoidal saw, up and down to adjust again, if is the double collocation combination of sawing, gasket placement must be reasonable. Insufficient pressure beam pressure automatic cutting saw plate, slightly run can also cause the edge collapse, the table on the right table saw by the ruler and the main blade must be in parallel over the outlet than the inlet slightly greater 0.2-0.3MM, this material will not be scratched at the end of the main saw to make adult edge collapse as the slide table saw is also less powerful, not straight plate processing, edge collapse also can hardly be avoided.
