Home > categories > Construction & Real Estate > Plastic Flooring > How to spread plastic floor tiles
Question:

How to spread plastic floor tiles

nan

Answer:

Floor tile shop: cement and sand mixed with water, into a dry and wet dry cement mortar (dry and wet consistency, with hands into a group is not loose). Advance the cushion layer of cement mortar, (using a dry cement mortar ratio three) in accordance with the horizontal exploration shop flat, the brick on the mortar with a wooden hammer tap, carry paimo. Take off the floor brick poured cement paste, and then put the floor tiles can be flat vibration.
Wet floor tile shop: cement and sand and water mixing into cement mortar (dry wet like rigid cement mortar plus a lot more). Before laying along the wall popped out of the ground elevation line, and then do the ash cake around the room, (ash cake is painted or pouring floor when Mason used to control the building elevation and surface flatness and verticality of cement blocks.) The surface of the cake should be lower than that of the floor, and the thickness of the floor tile should be lower. Finally, use a rubber hammer to crack down.
Ground mark: the first floor of the ground height is set to the relative elevation of the zero, with nylon thread or cotton rope on the ground pull out the ground mark line, as well as the vertical cross positioning line. Position the tile according to the position of the positioning line.

Share to: