How to use the centrifugal oil filter properly?
5) the user should mainly consider the establishment of reserved operating space, and the surrounding building spacing of not less than 1 meters, there is no lifting device on the centrifuge, easy to maintain the fashion centrifuge.3 preparation before starting1) the lubrication of each lubrication position shall meet the requirements, and the grease or oil in the bearings shall be filled with no leakage.2) check whether the feed pipe is firm and correct.3) all connection bolts shall be fastened and the belt tensioning should be moderate.4) point motor, check whether the turn of the source motor is consistent with the required direction (from the end of the liquid outlet, the drum should be clockwise rotation); whether there is abnormal friction arising from abnormal sound.
3) suspension gear pump directly into the centrifuge, the feed pressure in accordance with the concentration of suspension, viscosity and processing capacity, usually around 0.05-0.15MPa. The material must pass through the coarse material removal of debris, to prevent the discharge tube and centrifuge dusseldorf.4) the sediment sent by the centrifuge can be transported by belt conveyer, spiral propulsion shaft or artificial transportation, etc. the separated green liquid can be discharged by pipeline.
Installation requirements and preparation prior to use1 mounting dimensionsSee overall performance and overall dimensions of the main technical parameter table.2 installation1) the basis for the installation of centrifuges must be firm and smooth, with a flatness of less than 1mm per square meter, and easy to operate and maintain. All pipe connections that are connected to the mechanical centrifuge shall have flexible joints.
4 bootStart the main engine. After running for a period of time, stop and check if the parts have rubbing. If you have, you must find out the cause and eliminate it.5 operation check1) is the temperature and separation performance of the machine in steady state?.2) there is no leakage of the sealing parts.3) whether there is any increase in vibration or noise; if it is increased, the cause must be ascertained.4) the working current of the motor is normal, whether the current fluctuates greatly.5) should always check the main bearing temperature, the temperature less than 75 DEG C, the temperature difference is less than or equal to 35 DEG C, bearing temperature is too high to be down to check the cause and shall be excluded.
