Can the medium and high pressure system fail to use the raw meal belt, and can the raw meal belt be corroded into the oil circuit by the oil corrosion?What kind of sealant do you use? Recommend it
Hydraulic is not high temperature oil, usually with O ring, can not seal the oil, is not the joint surface is not good, can not cut off the replacement of joints, raw rubber tape, sealant is not reliable
It is best not to use, with American conical teeth hard seal, NPTF generally very few people with this. High precision ah!
Use sealant.It is not recommended to use the raw meal belt and can not be sealed. It will cause oil leakage. The raw meal belt will be contaminated by the oil, which is particularly easy to cause the phenomenon of the valve or plug the oil control port. If you must use the raw meal belt, then you must pay attention to the coil when you can not bring the raw material out of the joint, so as not to be sucked into the tank by oil.
