i have ckecked all hoses and fluid level . when i try to raise lift it tries to lift but it is already at the top . i push lever to go down and nothing happons
Assuming you mean the two (left and right) lower lift arms that comprise the 3 point hitch. Also assuming that there is no implement presently attached to these two lower arms and the top link. Further assuming that you have 2 levers that control the lift arms (one lever controls position and the other lever controls breakout draft effort), both of these levers must be in the down position which is generally forward (toward the front axle) on most tractors. Finally, on some tractors, the weight of the two arms is insufficient to go down with the force of gravity alone, and this is more often seen with brand new tractors. So assuming that you have done all the preceeding then simply go to the rear of the tractor with engine off and two levers forward and stand on one of the lift arms. It should go down. If this fails, then it is possible that hooking op the hydraulics for the front end loader was done incorrectly if problem did not occur until after installation of front end loader
