I have an immersion heater in my hot water cylinder (UK airing cubbard), but the wiring isn't connected. But, I seem to be missing a small piece or two. The previous lead wire from the timer/switch is stil there and has two wires in it. Does someone have a generic wiring digram showing which wires connect to the thermostat and which wires connect to the heating element? Thanks!
Immersion Heater Thermostat Wiring Diagram
Normal wiring with two connections on thermostat, on from timer and two on element would be a single wire from one of the timer wires to one connection on thermostat, one wire from other connection on thermostat to heater connection, then one wire from other heater connection back to remaining connection on timer. This is if the thermostat is high voltage and not a low voltage signal to a controller perhaps on the timer.
