Home > categories > Hardware > Fence > Install infrared fence shots. Use power line and monitor signal line. Can you use one line instead of signal line or power line?
Question:

Install infrared fence shots. Use power line and monitor signal line. Can you use one line instead of signal line or power line?

Install infrared fence shots. Use power line and monitor signal line. Can you use one line instead of signal line or power line?

Answer:

Can use the power cord instead. The power is very small, and the 2*0.3 power line is enough. Power line 220V, with transformer into 12V, if the centralized control power line 12V, the power line to be bold, within 50 meters with 2*0.5, more than 50 meters diameter to be thicker, otherwise the voltage will be more. If the distance is not far, within 20 meters, the power line and signal line with 0.5MM cable (pay attention to line diameter of not less than 0.5 copper wire, so cloth one is done, more than 20 meters is unstable)
Solar wireless infrared emission, solar power supply and signal wireless transmission, the installation does not require power lines and signal lines.For many security engineering companies, the installation of wired infrared radiation, the need to lay power lines and signal lines, the vast majority of time spent on trenching wiring, installation and maintenance are extremely cumbersome. "Solar wireless infrared" on the radio in the cable based on the working principle, the use of solar power and signal wireless transmission technology, so as to solve the problem of power supply and signal transmission, without laying any wire installation, so as to achieve full wireless installation, for security project to bring great convenience.
General IR fence has two components (a transmitter and a receiver), the transmitter will use 2 core wires (power line line), the receiver will need the power and signal line, due to power supply with 2 core, 2 core signal, you use the 1 type cable, infrared fence generally, not far from the host, the power is 12V, the signal for the switch signal, will not be subject to any interference, so the layout of 1 more than 4 core lines, but also the best core number of backup, so affordable is most suitable for the cable (distance it is best to use RVV4*0.75 or RVV4 *1.0. If the transmitter and receiver share 1 lines, remember that the power should be connected in parallel to maintain the 12V voltage, the power supply with a good point of power on the type.

Share to: