Does this resin off-gas or release anything in its cured state, when heated (like a plate in the oven or microwave–although it probably would melt), or at room temperature with hot or acidic food served on it? I am weary of the formaldehyde used in it's creation.
Yeah it may feel better.. BUT your putting undo stress on either end of the CV joint or transfer case or differential or however your vehicles axles are attached. going over them straight allows the car to raise and lower equally.
Offset printing is a widely used printing technique where the inked image is transferred (or offset) from a plate to a rubber blanket, then to the printing surface. When used in combination with the lithographic process, which is based on the repulsion of oil and water, the offset technique employs a flat (planographic) image carrier on which the image to be printed obtains ink from ink roller
