Is the bulldozer easy to learn?
Bulldozer learning:1. general provisions1.1 drivers must be familiar with the structure, performance and use of each part of the vehicle. They will be able to drive, maintain, and eliminate simple faults.1.2 the commander must implement the responsibility system, the commander directly responsible for normal operation, the vehicle safety. 1.3 bulldozers are not allowed to operate in spite of illness. In driving, found abnormal sound, fever and other abnormal circumstances, should stop immediately, find out the cause, before the troubleshooting can continue to drive. After returning, should report to the relevant department in time, and make the corresponding record.1.4 cold season should be replaced antifreeze. When cooling water is used, when the temperature is below 5 degrees Celsius, the cooling water is added with hot water about 80 DEG C, and the water is closed after the water outlet switch is boiled out, and the water is filled.
2.7, such as in the cold region or environmental temperature below +5 degrees Celsius, the use of heating to 90-95 degrees of cooling water added. When the hot cooling water is added to the water tank, the valve is closed when the drain valve is out of hot water, and then the supplement is added. 2.8 manual fuel shut-off valve or electric fuel shut-off valve.2.9 push the main clutch lever forward so that the main clutch is in a "separation" state. Put back and forth lever in required position. Position separation drive mechanism or separation lever in neutral position. 2.10 check whether there is any stone or dust in the track, and clean it.The bulldozer is the United States AMD company to re design of the CPU architecture, officially launched in October 2011, have a fever for high-end user, with DDR3-1866MHz native memory support, XOP instruction set, the modular design and a number of new features, fully replace the phenom processor of II series.
2. check before work2.1 check engine radiator cooling water, crankcase oil and fill it up. Check the oil content of the diesel tank and drain the precipitation water; add cooling water in summer; cold or cold water should be added in winter or cold area. Check whether there is oil leakage, leakage, etc., and find out the problems and solve them in time.2.2 check the lubrication points, check the engine oil, sump oil, and gear oil. Check whether the power supply system is broken, short circuit or loose joint.2.3 check all parts of the bolts, nuts and loose and lost, if there should be promptly tightened or filled.2.4 remove the dirt, dust and other parts of the machine parts.2.5 open the oil pipe valve and eliminate the gas in the pipeline.2.6 turn the throttle to the idle position. And disengage the engine from the drive.
