Is the gauge of the car much more toxic than the plastic instrument?
Potential disadvantages: mold investment, short life, the general quality of the mold only 20000 epidermal life; mold needs to be cleaned up, auxiliary hours consumption
The mold shall be heated before loading or after loading so as to change the material into a gel on the inner wall of the mold. When the gel reaches a predetermined thickness, the excess liquid material is poured out and then heated to melt. After cooling, the product is stripped from the mold. Because the surface pattern of the plastic lining is formed during the formation of the epidermis, the consistency of the pattern surface is good. In product design, as long as the local heating of the mold can be taken care of, the mold can do a deeper depression, and even make a certain negative angle, so that the product design margin is greater, the cost of materials is relatively low.
Slush molding is a method of molding hollow products. When molding, the paste is poured into the open hollow mold until the specified capacity is reached.
