Home > categories > Minerals & Metallurgy > Aluminum Foils > is this a good amp for my sub?
Question:

is this a good amp for my sub?

AMP I FOUND FORSALE Output Power(max/Peak) 500Watts(250W x 2 Load 4 ohms) Bridged Output Power(max/Peak) 500Watts(500W x 1 Load 4 ohms) Frequency Response 20Hz~20KHz ±1dB Input Sensitivity lt; 200mv Treble Control ±10dB 10KHz Bass Control ±10dB 80Hz Signal/Noise Ratio 95dB Speaker Impedance Stereo Output 2~16 Ω Bridged Output 4~16 Ω Power Supply DC 12V Dimensions 285(L) x 199(W) x 49(H) mm FOR SUB I GOT30cm (12”) Component Subwoofer 800W Max TS-W302R FEATURES: IMPP cone Aluminium voice coil bobbin Single nomex damper Copper round wire long voice coil Extended and vented pole yoke Single 4 Ω voice coil

Answer:

check the question above about Conduit That will solve the proband HD or lowes has miles of it Buy a section,,,cut it to lengths testing the tone and decide on the hammer, drill holes for the attachments, then put it together, and enjoy RevSteven
home depot or lowe'sThey will even cut it for youI bet Ace Hardware will have something comparable if its a decently large store.
yeah it should be fine just make sure to bridge the amp to get more power and when buying an amp tryi to go by one that says the rms rating of the amp and the rms rating on the sub
depends were you are but most steel suppliers or go to a welding supplier and they will tell youLook those names up in the yellow pages.

Share to: