Home > categories > Textiles & Leather Products > Pillow Case > It's convenient and neat to cut a piece of cloth from a piece of cloth to cut it
Question:

It's convenient and neat to cut a piece of cloth from a piece of cloth to cut it

It's convenient and neat to cut a piece of cloth from a piece of cloth to cut it

Answer:

Finishing cloth. Spread the wet cloth over the clean table to see if the fabric is normal in proportion. Usually, the twill fabric will be twisted, at this point, the diagonal direction of the twill will gently stretch the material and correct the direction of the fiber. Usually stretch in an oblique direction. If it is a Chaoyang fabric, you can easily observe the direction of the skew, stretching in its diagonal direction to the flat vertical.
Location。 Draw a weft or warp from the place where the hot material needs to be cut, and cut it along the trail of the missing yarn, so it's neat.
Ironing qualitative. Spread the cloth over the table and gently press the iron. Take care not to press hard, otherwise it will wrinkle.
You have to thread the cloth first. Can use different from the first color chalk on paper seedlings over the drawing of the contour, and then the paper over spreading in the cloth, with the crossed hand wheel along the back of the paper describe again, transfers to the cloth in the chalk. Attention: the ironing should be completely ironed and dried and cut. Because the wet fabric is easily pulled and deformed, it is easily cut off when it is not found.
1, completely soaked, that is, cloth directly into the water, gently rinse, and then hung to half dry (do not hand twist or dry). Do not understand the fabric properties, do not use, in case of deformation, decolorization is not easy.2, for those who do not know the property of cloth, or that does not require the launching of cloth. Spray a spray of water evenly over it and fold it into a clean, large plastic bag for 1 or 2 hours. So that the water vapor is evenly distributed, so that the fabric wet.

Share to: