My impression is "multi line" (PL) to draw the ==||||| I forgot, ha ha, you can try
Well, if you want to paint it yourself, I'll probably tell you about it,,The first part of the 23cm should be no problem, say the hook part..First dotted at the intersection of 24 diameter circle, and then draw T with vertical and tangential circle diameter of 24 intersecting circles, after pruning that arc.. Draw a circle with a radius of 29 and a radius of the right on the same side as the radius of the circle of 24..And then the lower left part, draw a circle with a radius of 36 from the point of intersection of the line, find the intersection of the horizontal line at the bottom of the intersection point of 9 points (because the radius of the tip part of the radius of the circle of 24 tangent). So we can find the intersection of the 24 circles.. Circle at the intersection.The radius of 14 circle and the radius of 29 circle tangent point in the horizontal line intersection point line, so it can draw out.. Then use the tangent radiusDraw a circle with a radius of 2, trim.. Just fine
CAD hook Description: as shown in FigureDrawing auxiliary lines with the center line, red auxiliary line, then draw the above linear part, then draw the circle, draw two vertical lines below without accurate length, while also pruning.Draw circle: with tangent, tangent, radius command circle, draw the circle of R32 and R22.4.Trim.To 21.6 of the center of the circle as the center of the circle (R21.6+R21.6+ phi) for the diameter of the circle, for the phi 64.8 round (21.6).Draw a circle with a radius of 64.8 yuan and the following horizontal auxiliary line as the center, the radius is R21.6.Remove the auxiliary circle, draw the circle of the R12, and the center of the circle.Draw circles, tangent, tangent.The radius of the circle to draw the command R2.4, and R12, R21.6 tangent to the circle.Trim.Tagging。
