Turn on the light and the molding lamp is on normally. Any light is normal.Flash by body, no response, flash is not OKI do not know whether the hardware problem or what problems have been in use, and found today not flashing.
Fix it. Maybe the flash tube is broken.
The problem of a light tube or capacitor circuit board.Suggest that you can buy a tube first, try it on (if you use a multimeter, measure it, no resistance is broken)If it is not the problem of lights, it is recommended to go back to the factory to repair the best.Suddenly, such a bad case is likely to be a circuit problem.
You can put the good tube on this and try it. Before the change, the best flash has been discharged, or one or two days did not pass the electricity. If it turns out to be a light tube, you can go to Taobao and buy one and change it back.
