Led how to install the lamp belt, LED lights with the installation process detailed
Please do not use heavy objects to knock on the lamp and to shock when installing and using it.At the end of 7. tube must be caught before the tail plug with glue.8. only the same specifications, the same voltage of the two section of the lamp string can be connected to each other, the total length of the series shall not exceed the maximum allowable length9., the interface must be solid, no short-circuit hazards, outdoor installation, the interface must be glass glue or other appropriate methods to seal the interface, to ensure that each interface water.
The installation of LED lamp belt under cold temperature can be electrified for a few minutes, so that the lamp body becomes soft, easy to bend, and then power off installation.
Do not use the power supply during the installation or assembly of the lamp belt. Only the connection, installation and the correct condition can be used to connect the power supply,
When installed, please bring light bent to one side, exposing the 2-3MM copper wire, and wire cutters cut clean, there shall be no burr, avoid short-circuit.
Please don't light the band when the 1.LED light is in a roll.2., only on the lamp belt with a scissors mark on the body to cut, otherwise it will cause a unit is not bright.