Note: the installation of the LED lamp with LED lamp belt compared to traditional lighting, or are in the development of new products, so many consumers on how to install the LED lamp belt is not very understanding, in the installation process may occur in a variety of problems led lights with LED can not be used, the correct use and installation of the LED lamp belt extend the LED lamp with life, we also need to understand the problem. LED lamp belt at the time of installation, must be in accordance with the concise, use the correct method to carry out the installation, if excessive distortion or incorrect use of the installation method, are easy to light with losses, reduce the lamp with the use of time, is not conducive to the maintenance of the lights.
Each band must be equipped with a dedicated plug (plug with a transformer), the connection must be removed from the transparent plastic cover, and then put on the test light and then covered. It must not be connected directly with a cover, so it is easy to short-circuit! 5. outdoor installation: outdoor installation due to withstand wind and rain, if the use of fixed 3M glue, a long time will cause the decrease of the 3M adhesive LED lights off, so often used for outdoor installation fixed card slot, need to cut and connected and installed in the same place, method, just need to also equipped with waterproof glue, waterproof effect to consolidate the connection point.
Note that the LED light belt connection distance: Generally speaking, the 3528 series of LED lights belt, its connection distance is 20 meters long, 5050 series of LED lamp belt, the longest connection distance is 15 meters. If the connection distance is exceeded, the LED light band is easy to heat, and the service life of the LED light belt will be affected during use. Therefore, the installation must be in accordance with the requirements of the installation of manufacturers, should not let the LED lights with overload operation.
Provide the following installation should pay attention to the details of several lights for everyone: 1. power connection method: general voltage LED lamp with DC 12V, necessitating the use of switching power supply, power supply according to the size of the power LED lamp belt and connected to fixed length. If you do not want to take each LED lamp with a power to control, switching power supply can buy a relatively large power for the total power supply, then put all LED light with all input power in parallel (wire size is not enough, can also extend) unified by the total power switch. This advantage can be centralized control, inconvenient place is unable to achieve a single LED lamp band lighting effect and switch control, which specific way to be measured by their own. 2., each meter has "scissors" mark, only in the mark must be cut, scissors or scissors will lead to one meter does not light, it is best to carefully look at the location before the mark, according to the middle of the connection can not cut it.
Indoor installation: LED lights for indoor decoration, because of not having to undergo the installation is very simple so exposed to wind and rain. The ordinary LED lamp belt as an example, behind each LED lamp belt are affixed with self-adhesive 3M double-sided adhesive, the installation can be directly off the surface of the 3M double-sided adhesive stickers, and then the lamp strip is fixed on the installation place, hand press flat is good. As for some places need to corner or long, how? Very simple, LED light belt is a series of 3 LED as a series of parallel circuit structure, each 3 LED that can be cut alone. 7. controller connection: LED and RGB lights with marquee with the need to use the controller to achieve varying effect, while the control distance of each controller is not the same, in general, simple controller for 10 control distance to 15 meters, distance control remote controller is 15 to 20 meters, the longest can be controlled to a distance of 30 meters. If the length of the LED band is longer and the controller cannot control the length of the band, then the power amplifier will be used to tap it.
