A middle transverse plate and the riser 90 degrees put away with the connecting handle and connecting rod. The first white plastic screw inserted into the connection lever, and then use the screwdriver to tighten the connecting handle twist.Installed in the middle, mounted on both sides of the bed board fixed bedside, and then put on the bed board on the line.There is a drawer at the end of the bed or on the side of the bed. It is very simple. The drawer is made up of three sides, the bottom plate is inserted into the slot, each side is provided with a slide rail, and each of the frames is provided with a slide, and then slide in. Metal buckle installed.The bedside table is mainly a drawer slide, and the same way as the drawer of the bed.
First, there should be a simple assembly instructions, you look for, with reference to engage in.Second, but also to see what kind of bed, basically similar to the assembly of computer tables, are first to a piece, and then use the fastener rotation 90 degrees to lock.
If there is any damage to the sheet during the inspection, please contact the merchant. To install screws, eccentric parts, wooden shaft of the place, will open a good guide hole, parts of the positioning problem, do not worry. It should be noted that, do not happen on the wrong parts, and then repeatedly twist the case, otherwise it is easy to damage the plate, installation is also often unstable, tilt and other phenomena.
Carefully read the installation drawings of mounting plate in front of the bed, and prepare common tools, such as flat cross screwdriver and hammer etc.. Apart from the packaging, it is best not to mix, and if similar parts are more, the drawings will draw a physical size of the comparison diagram, the parts do not fork, it is easy to distinguish between various parts
