I need to clean my skateboard bearings but im not sure what type of liquid i should use to clean them?Acetone or Mineral/White spirits?
WD40! Get a can and a small dish / bowl... Fill the bowl up 3/4 full with this WD40 and let the bearing soak in it over night. The next morning you can pull them out and wipe them down... Finally just grease the bearings and put them back in.
No bro! NEVER! EVER! Use WD-40! Maybe just a 5 sec dip BUT NEVER USE WD 40 ON BEARINGS! It'll eat right through it! Use maybe acetone.. its less acid but is still a bit hard.. I usually clean mine by rubbing them with tissue, then put some oil on the tissue and slightly pass it throught.. not to get the liquid stuck in between..
i easily basically lubed my bearings yesterdday. do not use Wd-40 it may desire to look extra useful in spite of the undeniable fact that it attracts extra airborne dirt and dust than it would routinely. on account which you have Bones get Bones speed Cream RF. Bones additionally make cleansing undemanding for there is in basic terms one shield that needs to be taken off it fairly is the purple shield. To take them of basically get a thumb tack and bypass interior the hollow between the steel and the shield and placed it in and pry it off. it is going to then snap back in after cleansing. additionally once you purchase speed Cream it components all the instructions.
