Normally, the proportion between submerged arc welding wire and flux should be answered
My company uses the "Golden Bridge" submerged arc welding wire and flux, welding wire and welding flux together, can not be separated, how is it? It is normal. Submerged arc welding usually has an arc lead plate and a draw plate
And the width of the weld, in general, the wider the weld, the greater the solder loss.
1:1 or so. The amount of filling welding is less, but the amount of cover welding is more. When the steel plate is no more than 9mm thick, the flux requirement is the same. If the production plan is reported, according to your total amount of work, the total length of the weld is greater, the results of the added proportion is smaller.
