Operation of centrifugal oil filter
2. separation(1) open the water sealed water valve and seal the water to the outlet of the sewage.(2) slowly change the valve, add the dirty oil to the drum.(3) adjust the oil inlet valve and mediate the proper handling capacity.(4) adjust the pressure of the net oil outlet and enter the normal separation state.
Check motor steering. Especially after the first start-up or the overhaul of the motor equipment. 1. start(1) start the separator, if the machine vibration abnormal, should stop immediately, check the drum assembly.(2) after the parts are normal, restart the separator. Due to the large inertia of the drum, the instantaneous load at the start of the motor will exceed the rated value, and the current will increase rapidly. When the separator reaches the rated speed, the current is stable and lower than the rated value of the motor. It takes about 5 minutes to start the whole process. When the speed is in accordance with the main technical parameters of the separator, it indicates that the separator has reached full speed.
Check that the machine is properly assembledCheck that the ring is suitableCheck that the brake (brake) is released.Rotating drum body is flexible, whether or not stuck phenomenon.Check that the oil level in the tank is correct.Check that the recycling system is normal.
3. stopA. turn off the heater and switch the valve to allow the sump oil to enter the sump tank through the recirculation system net.B. cut off the power supply. If the separator is to stop as soon as possible, the brake (brake) can be used after the speed drops to 1000 rpm. To avoid excessive wear of the friction disc, the drum speed is more than 1000 revolutions per minute, as much as possible without the use of the brake.C. the drum must be cleaned every time the work is done;Caution: do not loosen any fasteners on the machine until the drum has stopped completely. Points for attention in the use of edible oil filter
