Production of cement poles need some equipment
according to the length of the pole with a straightening cut wire cut off the cut, the wire is made of cement rods tend to (equivalent to weft).
and then through the gantry crane, hanging to the rectangular semi-underground large container inside, the rectangular container connected to the boiler, the equivalent of a large steamer.
filled with cement after the top of the mold, two loaded with a pull-up disc (prestressed concrete poles need to pull up, self-stress concrete pole can be directly produced).
, the straight wire of each wire rods at least 8 tendons, some pole factory in order to stabilize the requirements are 12 tendons (which is more than one bar). At the same time with a thin steel wire into the corridor of the weft, around the weft as the wire, the combination of wire tied with a tie, so that there is a cement in the mold pole of the cement. And then with a certain percentage of cement poured over.
, the first need to wire straight, inside the room there is a wire rod machine, because the backlight did not take it, it bundles a bundle of steel wire straight.
