After the schematic is imported into the PCB, after layout and routing, it is a single panel. How to draw a double panel? Specific steps also please prawn guide, thank you
The default settings, after the introduction of two lines, toplayer and bottomlayer, respectively, the top and bottom. Respectively, in the two layers of the line, that is, 2-layer, if only in which a layer of painting, is a single panel;
L out of the board dialog box, the bottom of the hook is not the bottom and the top of the double panel! But have the layout and wiring!
The second you can set the routing priority (Roufing Priority). You can set the priority of the wiring, the high priority of the network wiring first cloth, the lower the priority of the network wiring late. You can set the GND network to 0 0 represents the lowest priority, so on the line. Select the [Routing Priority] option in the [Rules Classes] option list box and click the Properties option to enter the Routing Priority parameter setting dialog box.
The check box, so that check box appears in the check mark "√" to open the work level. According to what you said you are painting the bottom is not convenient, then you will 'Top' in front of the sign "√" removed on the line. Need to check again.
Execute the menu command [Design] / [Options], the [Docunent Options] dialog box appears, select the Layers tab to enter the dialog box at the job level. There is a check box in front of each working level.